If I try to log a USB UASP SCSI DEVICE (an external hdd in an USB/SATA enclosure with a JMICRON controller) I get this:
Frame 286: 59 bytes on wire (472 bits), 59 bytes captured (472 bits) on interface \\.\USBPcap1, id 0
Section number: 1
Interface id: 0 (\\.\USBPcap1)
Encapsulation type: USB packets with USBPcap header (152)
Arrival Time: Jan 26, 2023 10:39:04.214840000 Egypt Standard Time
[Time shift for this packet: 0.000000000 seconds]
Epoch Time: 1674722344.214840000 seconds
[Time delta from previous captured frame: 0.000009000 seconds]
[Time delta from previous displayed frame: 0.000009000 seconds]
[Time since reference or first frame: 38.717323000 seconds]
Frame Number: 286
Frame Length: 59 bytes (472 bits)
Capture Length: 59 bytes (472 bits)
[Frame is marked: False]
[Frame is ignored: False]
[Protocols in frame: usb]
USB URB
[Source: host]
<Source or Destination: host>
[Destination: 1.22.1]
<Source or Destination: 1.22.1>
USBPcap pseudoheader length: 27
IRP ID: 0xffff810bfe09faa0
IRP USBD_STATUS: USBD_STATUS_SUCCESS (0x00000000)
URB Function: URB_FUNCTION_BULK_OR_INTERRUPT_TRANSFER (0x0009)
IRP information: 0x00, Direction: FDO -> PDO
URB bus id: 1
Device address: 22
Endpoint: 0x01, Direction: OUT
URB transfer type: URB_BULK (0x03)
Packet Data Length: 32
[Response in: 287]
[bInterfaceClass: Mass Storage (0x08)]
Leftover Capture Data: 0100000200000000000000000000000012018000fe0000000000000000000000
The issued SCSI command was obviously "12 01 80 00 fe 00" But it's not decoded as SCSI and show just as URB out.
What should I do to get a SCSI decoding?