My devices keep logging on and off my Wifi. I want to find the reason why this is happening. I have already tried all kinds of ways to find out such as manually selecting a low-used channel etc. All my devices have the latest Wifi drivers. So how can I use Wireshark to find the reason why my devices keep loosing the Wifi connection and then connect again?
You use Wireshark by observing the connection sequence, probably:
open authentication --> association --> 4-way EAPOL handshake for auth+keying
and then the tear down sequence, probably a single management frame, either
disassociate or deauth
This could be more about cutting the problem in half instead of the brass ring - know exact root cause. Anyway, sometimes we get lucky. Either side can choose to leave the association, so you would see who is issuing the leave, and there is a field that might contain a reason code. Hopefully it doesn't say 'unspecified'... this is the jumping off point. Whichever entity is leaving, you need to look there - why are they sending that frame? A real reason code is a great starting clue. Often, you will need logs as Wireshark only shows what happened, but does not always show why it happened.
Things like power save behavior, DHCP timeouts, and session timeouts are common reasons why a host might leave a wireless association.
Wireless packet capture is hard but there is some guidance here. Often, special hardware is needed.
Thanks for this answer. However, I am new to Wireshark and therefore don't know what you mean with
open authentication --> association --> 4-way EAPOL handshake for auth+keying
How do I do this in Wireshark?
Some options:
I am capturing wifi traffic with my router (fritzbox). Would that be enough to do the analysis?
I assume you have checked logs, if any, in the AP? If it is capturing 802.11 traffic then it might be useful. However, most of the vendors have some type of capture solution on the products (mid to high end) but they always have issues when trying to get ALL traffic. But you don't need ALL traffic, you need to see how the device is behaving and if/when/how the device is leaving the association so it MIGHT be suitable to get started.
If you are comfortable, make a link to a download of the capture and provide the MAC of the problem device and we can take a look.
Asked: 2020-05-26 21:12:31 +0000
Seen: 1,005 times
Last updated: May 26 '20
Copyright Wireshark Foundation, 2017-2023 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
