hi -
I have spurious issues
How do i setup wireshark to watch multiple wifi channels ?
I know i must be dropping packets sometimes - just dont know specifics.
Need traffic log so i can look at and time behaviour to performance
thanks
If you only need your network with your AP, most APs today have two radios, one 2.4 and one 5GHz (high end ones sometimes have three radios). This would require two wireless radios, so two wireless adapters. A single Macbook will be tough; it has one radio that works great, but only one (two Macbooks would do nicely...). Windows is tough, in general, for Wireless sniffing so that is not an attractive choice. Linux would be a good choice, as you can use many WiFi adapters at the same time, either some form of newer PCI (miniPCIe, M.2, etc.) or USB, or a mix of both.
With each adapter configured for the specific channel and modulations, have Wireshark capture on both adapters at the same time; shift + mouse select usually works on the current version of Wireshark under Capture --> Options --> Input to select multiple interfaces.
For CLI use, dumpcap is useful as you can pass multiple interface options, simple example:
dumpcap -i wlan1 -i wlan6 -i wlan11 -s 0 -g -w somefile.pcap
tcpdump does not seem to support multiple adapters at the same time. Omnipeek, a commercial packet capture alternative that is very much not free, can handle multiple interfaces as well.
Exactly which adapters to use and how to configure them for monitor mode depends entirely on what platform you choose and the specific traffic you need to capture.
Asked: 2019-08-04 11:20:58 +0000
Seen: 1,592 times
Last updated: Aug 04 '19
What do you consider all? All traffic on all 802.11 channels at the same time? All traffic from your specific network, which is likely only a single channel? Maybe just traffic on a specific band in use in your region?
Watching multiple channels at the same has two flavors, but we don't know what you need. The first is channel hopping, where the radio cycles through the channels. This captures a small amount of traffic on each channel, time sliced. Since the radio is only on one channel at a time, you can't pick up the other channels at the same time. The other option would be to capture on multiple adapters at the same time, then you get more or less all the traffic on those channels. The number of channels available to you is dependent on your region ...(more)
Thanks for the reply.
I want to watch 2.4 and 5 WiFi locally. I can put one system on each frequency if needed - since you mentioned I cannot watch what I am not connected to.
Some device is flooding "noise" - need to watch, wait to figure out next steps