 | 1 | initial version |
It depends on your configuration.
Edit => Preferences => Protocols. Then pick your protocol and see on which port(s) it will normally detect.
If you hit traffic on another port then it will not be decoded b default. However you can just right click on a relevant packet (SYN packets are not the best for this) and tell Wireshark to decode traffic on this port as the protocol you want.
If this hapens a lot I suggest you add the port to protocol settings. If it only happens once I wouldn't bother with that.
Regards, Hugo.
Copyright Wireshark Foundation, 2017-2023 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
