| 2021-02-25 00:03:16 +0000 | received badge | ● Famous Question (source) |
| 2019-08-25 04:51:03 +0000 | received badge | ● Notable Question (source) |
| 2019-08-25 04:51:03 +0000 | received badge | ● Popular Question (source) |
| 2019-04-25 13:09:14 +0000 | received badge | ● Famous Question (source) |
| 2019-04-25 13:09:14 +0000 | received badge | ● Notable Question (source) |
| 2019-04-25 13:09:14 +0000 | received badge | ● Popular Question (source) |
| 2018-10-17 21:42:15 +0000 | commented answer | How to set up Wireshark to read SPAN destination traffic Ok, after additional testing I tried using different PCs as the monitoring PC. It turns out my configuration was correc |
| 2018-10-11 22:11:27 +0000 | commented answer | How to set up Wireshark to read SPAN destination traffic yes I configured as follows: monitor session 1 source g1/0/1 monitor session 1 destination g1/0/3 To verify I used: sh |
| 2018-10-11 22:11:17 +0000 | commented answer | How to set up Wireshark to read SPAN destination traffic yes I configured as follows: monitor session 1 source g1/0/1 monitor session 1 destination g1/0/3 To verify I used: sh |
| 2018-10-11 22:08:54 +0000 | commented answer | How to set up Wireshark to read SPAN destination traffic I ran some tests based on your comments and results were as followed: 1. I confirmed that the capture PC loses connecti |
| 2018-10-11 00:01:56 +0000 | commented answer | How to set up Wireshark to read SPAN destination traffic I am using a Cisco Catalyst 2960S switch. There is traffic but just arp messages, no ICMP even if I ping accross both so |
| 2018-10-10 15:43:47 +0000 | received badge | ● Editor (source) |
| 2018-10-10 15:43:47 +0000 | edited question | How to set up Wireshark to read SPAN destination traffic How to set up Wireshark to read SPAN destination traffice I am unable to get wireshark to read a SPAN destination port t |
| 2018-10-10 15:42:04 +0000 | asked a question | How to set up Wireshark to read SPAN destination traffic How to set up Wireshark to read SPAN destination traffice I am unable to get wireshark to read a SPAN destination port t |
| 2018-09-28 21:26:27 +0000 | received badge | ● Rapid Responder |
| 2018-09-28 21:26:27 +0000 | answered a question | Follow Stream error message Is there another way to follow a stream, other than going to statistics, then conversations? What about from the packet |
| 2018-09-28 18:36:51 +0000 | asked a question | Follow Stream error message Follow Stream error message I'm not sure how to post a question. The search bar says to ask your question there, and it |